What should I do if the LED indicates 'Motor connected to wrong socket or wrong arm system configured on AS-dips' on my Assa Abloy Garage Door Opener?
To resolve the issue where the 'LED indicates Motor connected to wrong socket or wrong arm system configured on AS-dips' on your Assa Abloy Garage Door Opener, disconnect the mains, then correct the motor connection and the arm systems dips.
What does it mean when the LED indicates 'Blocking door and constant impulse' on my Assa Abloy SW300 Garage Door Opener?
To address the 'LED indicates Blocking door and constant impulse' error on your Assa Abloy Garage Door Opener, toggle the impulse.
General| Brand | ASSA ABLOY |
|---|---|
| Model | SW300 |
| Closing Speed | 10°/s |
| Hold-Open Time | Adjustable |
| Operating Temperature | -20°C to +55°C |
Defines the product's intended application and essential safety precautions for users.
Details on managing electronic interference and environmental considerations for the operator.
Specifies permitted door weights and widths for SW300 and SW150 models.
Details operational principles, control switch functions, and basic CU features.
Covers extended torque, power assist, push-and-go, and presence detection features.
Explains functions on EXU-SI/SA, including KILL/FIRE, locks, and nurse/bed functionality.
Describes single, double, and double egress operator models.
Visual guide to identifying individual operator system components.
Step-by-step guide for installing the PUSH arm system on doors.
Detailed instructions for installing the PULL arm system on doors.
Information on double acting kits and drive shaft extension kits.
Details on control switches, sync cables, and coordination units.
Covers battery backup, closing time boards, and fire kits.
Essential safety advice and general guidelines before starting installation.
Illustrates installation scenarios and specifies wall fastening requirements.
Lists all necessary tools for the mechanical and electrical installation of the operator.
Comprehensive guide for installing the PUSH arm system, including measurements.
Comprehensive guide for installing the PULL arm system, including measurements.
Instructions for inverse installations and coordination unit setup.
Details on connecting mains supply and various control units like CU-300.
Explains EXU-SI/SA wiring and double door synchronization setup.
Guide for connecting sensor cables and fire door reset/indication devices.
Adjusting spring pre-tension and micro switch for proper door operation.
Steps for adjusting the door stop and performing the auto-learn function for calibration.
Covers hold open time, speed settings, and connecting activation units.
Instructions for fitting the operator cover and applying required door signage.
Procedures for advanced back-check/latch-check setup and reverting to default values.
Guide to changing parameter groups and classification levels for advanced control.
Setting up overhead presence detection and interlock functions for enhanced safety.
Guidance on safety devices and determining correct opening/closing times.
Diagrams to help calculate door weight based on dimensions and glass thickness.
Lists common faults, their possible causes, and recommended remedies for the operator.
Explanation of LED flash patterns indicating specific errors and their solutions.
To Next Page