S I G N A T U R E
12
7. Recommendations
7.1. PACKAGING
The AstralPool Chlore Elite system is supplied correctly packed in a sealed cardboard box
where the position and stacking information in order to be palletized is indicated. Any failure to
comply with these indications can result in damage of the product. The components that should
be found in the packaging are indicated in the operation manual.
7.2. STORAGE
The AstralPool Chlore Elite sytem must be stored indoors. UV rays o direct water contact can
damage the package.
Maximum temperature of storage: 50°C
Minimum temperature of storage: -5°C
7.3. TRANSPORT
System boxes must be transported on adequately secured pallets. Once at the installation,
transport the system to its nal location in the packaging. If this is not possible, the system
should be handled with maximum care.
Any frictions, bumps or contact with rough surfaces can cause damages to the external nish
appearance.
7.4. LOCATION
Always install the power supply of the AstralPool Clore Elite system vertically on a solid and rigid
surface (wall). In order to guarantee a good state of conservation, the power supply should be
installed in a well-ventilated dry place. Due to IP degree of the power supply of the AstralPool
Chlore Elite salt electrolysis system should not be installed outdoors. The power supply should
be installed a bit distant from the electrolysis cell so that it cannot accidentally suffer water
splashes.
Beware of corrosive atmosphere formation due to pH decreasing solutions (specially, those
ones based on hydrochloric acid “HCl”). Do not install the Astralpool Chlore System near to
any stores of these chemicals. We strongly recommend the use of chemicals based on sodium
bisulphate or diluted sulphuric acid.
To Next Page
Loading...
