Astralpool ELITE 60 - Operation; System on Stand-By; Production Level Selection

S I G N A T U R E
25
7.7. OPERATION
7.7.1. SYSTEM ON STAND-BY
The system goes into “STAND-BY” when the “-” [1] key is pressed successively until the “0%”
light blinks. When this occurs, there is no production in the electrolysis cell.
7.7.2. PRODUCTION LEVEL SELECTION
To select production level, press the “-” [1] / “+” [14] keys until the desired production level light
blinks. The system information screen [11] will display the value of the production scale light [4].
The system will set its production to the desired level after a few seconds.