S I G N A T U R E
26
In normal conditions, the production value [4] should be the same as the programmed value,
however, if the salt level in the water is outside the permitted range (“HIGH SALT” [7] or “LOW
SALT” [6] alarms on), or there is a problem in the electrolysis cell (“ELECTRODES” [13] alarm
on), the production value [4] could be lower than the programmed and displayed value [11].
7.7.3. SALINITY TEST
AstralPool Chlore Elite systems have an integrated system to detect the salinity level of pool
water. To run the test press the “SALT TEST” [9] key. During the test, the production light will
range from 20%-80% of the salinity scale
[5], alternately displaying “SALT” and “TEST” on the
system information screen [11]. Once the test is completed, the light will blink for a few seconds
on the scale [5] on the detected salinity value. The equipment will return to normal operating
mode after a few seconds.
The system might show lower than actual salt levels if the temperature falls beneath 20ºC.
NORMAL
EXCESS
HIGH
LOW
VERY LOW
To Next Page
Loading...
