Chapter 2: Hardware Information
2-16
5. Place the 2.5” hot-swap storage
device into the tray then secure it
with four screws.
7. Push the tray lever until it clicks and
secures the tray in place.
The tray is correctly placed when
its front edge aligns with the bay
edge.
8. Repeat steps 1 to 7 to install the
other storage devices.
Wheninstalled,theSATA/SAS/NVMeconnectoronthestoragedeviceconnectstothe
SATA/SAS/NVMeinterfaceonthebackplane.
6. Insert the tray and storage device
assembly all the way into the depth
of the bay until just a small fraction
of the tray edge protrudes.
To Next Page
Loading...
