ATAGO PRM-2000 A - Page 12

11
5-2. Mounting the Sample Inlet Unit
Fit the sample inlet unit into the leading section of the detection part, and secure the sample inlet unit
with the attached clamp and O-ring provided.
Fig.5-2
 Support of detection section 
Since the detection section weighs 4.1kg, it may not be supported by connection with the sample
inlet unit alone.Therefore, support the detection section, as shown below.If you cannot get the
support, we will supply the following parts.
・ Stand (RE-67155)
・ Pipe hanger 3S (RE-67157)
・ Hanger pin (RE-67156)
For the support bar, prepare a pipe having an outer diameter of 19.0mm and an inner diameter of
16.0 to 17.0mm.
Clamp
O-ring
(silicon or
EPDM)
O-ring
(silicon or EPDM)