16
TELEPHONE OPERATION
TELEPHONE OPERATION
Conference Calls
You can use both lines at the same time to set up a
three-way conference call.
1 Make or answer a call and press H.
2 Establish a call on the other line.
3 Press H, then press C. If you want
to change to another mode, you can press
K or h or lift the handset once
all parties are connected.
To end a conference call, hang up
If one caller hangs up during a conference call, you might
hear a dial tone. Press the LINE button of the remaining
call to disconnect the other line and eliminate the dial tone.
NOTE: Under certain circumstances, the far-end
parties on a conference call may not hear one another
clearly.
Place a conference call on Hold
1 Press H to hold both lines.
2 Press C to release Hold, then lift
the handset or press K or h
and continue your conference call.
Talk privately with one caller during a
conference call
1 Press H. Both lines are put on Hold.
2 Press the LINE button of the person with
whom you want to speak privately then lift
the handset or press K or h.
3 Press C to release Hold and continue
your conference call.
Drop one party from a conference call
To disconnect one party from a conference call and keep
the other on the line, press the LINE button of the call
you want to continue.
NOTE: If you leave the C button down after
a conference call, then dial another number, your call
might be completed, but you might hear a busy signal
from the other line. Press H, then press each LINE
button until you identify the line being used for your
completed call.
M
MM
MM M
MM
MM
M
MM
MM
M
MM
MMM
MM
MM M
MM
MMM
MM
MM
❖
❖❖
❖❖
To Next Page
Loading...
