Before You Install
To use this product as a two-line phone, you must have a two-line modular
wall jack or two separate one-line modular wall jacks. To use both lines
of a two-line telephone, your local telephone company must provide two
telephone numbers.
Battery Installation
Before using the telephone, you should install four AA batteries (purchased
separately). You can use the phone without batteries to dial and receive
calls using the handset. However, the LINE lights and the Automatic Redial
feature will not work, and the speakerphone and optional headset may not
work correctly in all conditions. To use the speakerphone without batteries,
you must press and hold K for one second.
This product is designed to operate optimally with two telephone lines.
If you choose to install only one telephone line, the phone will continue to
operate normally as long as the unused line is not selected. For example,
if you press l when there is only one line installed and that line is
connected to the L1/L2 jack, you will not be able to use the phone properly.
Simply press L and begin again.
î
NOTE: If you do not install batteries, you will hear a low battery warning
tone every time you lift the handset or press K.
CAUTION: Always unplug the line cord(s), before installing
new batteries.
1 Turn the telephone upside down.
2 If the base wedge is attached, remove the wedge by pressing
the tabs as shown and then pulling the wedge away from
the base.
continued on page 4
3
INSTALLATION
INSTALLATION
INSTALLATION
To Next Page
Loading...
Need help?
General
