213
RF Exposure Information (SAR)
This mobile phone meets the government’s requirements for exposure to
radio waves. This phone is designed and manufactured not to exceed
the emission limits for exposure to radio frequency (RF) energy set by the
Federal Communications Commission of the U.S. Government. The exposure
standard for wireless mobile phones employs a unit of measurement known
as the Specic Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/
kg. Tests for SAR are conducted using standard operating positions accepted
by the FCC with the hone transmitting at its highest certied power level in
all tested frequency bands. Although the SAR is determined at the highest
certied power level, the actual SAR level of the phone while operating can
be well below the maximum value. This is because the phone is designed
to operate at multiple power levels so as to use only the power required to
reach the network. In general, the closer you are to a wireless base station,
the lower the power output.
The highest SAR value for the model phone as reported to the FCC when
tested for use at the ear is 0.85W/kg, in hot spot mode is 1.33 W/kg, and when
worn on the body, as described in this user guide, is 0.96W/kg (Body-worn
measurements differ among phone models, depending upon available
accessories and FCC requirements.)
While there may be differences between the SAR levels of various phones and
at various positions, they all meet the government requirement.
The FCC has granted an Equipment Authorization for this model phone with
all reported SAR levels evaluated as in compliance with the FCC RF exposure
guidelines. SAR information on this model phone is on le with the FCC and
can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid
after searching on FCC ID: XD6U318AA.
For body worn operation, this phone has been tested and meets the FCC RF
To Next Page
Loading...
Need help?
General
