96
Adding and registering handsets/headsets/speakerphones
Your telephone can support up to 12 DECT 6.0 cordless handsets (AT&T model
CL80115, sold separately) or up to 10 cordless handsets and 2 cordless
headsets or speakerphones (sold separately). Visit
www.telephones.att.com/accessories for a list of compatible
DECT 6.0 cordless headsets and speakerphones. Each new handset, headset or
speakerphone must be registered to the telephone base before use. You must
register each handset, headset or speakerphone separately.
To register a cordless headset or speakerphone to this telephone system,
please refer to the corresponding user’s manual for more details. To register a
cordless handset, see below.
The handsets provided within your product box are already registered as
HANDSET 1, and so forth. Additional handsets are assigned numbers in the
sequential order they are registered (up to HANDSET 12).
Register a handset to the telephone base
Before you begin registration, put the handset you wish to
register near the telephone base. Make sure the handset
shows To register HS, see manual.
On the telephone base, press MENU/SELECT in idle mode.
On the telephone base, use qCID or pDIR to scroll to
Settings, then press MENU/SELECT.
On the telephone base, use qCID or pDIR to scroll to
Registration, then press MENU/SELECT.
Press # (pound key) on the handset. Both the handset
and the telephone base show Registering... Please wait
and the IN USE light turns on.
After a while, Both the handset and the telephone
base beep and the IN USE light turns off. HANDSET X
Registered appears on the handset screen (HANDSET represents the
handset name, X represents the handset number). The handset is now
registered with the telephone base.
If registration fails, the system will automatically try to register again. If
registration fails after the third try, Registration failed appears on the
handset screen. This may take up to five minutes to occur. Please start again
from Step 1.
NOTES:
You cannot register a handset if any other system handset is in use.
If you try to register more than 12 handsets to the telephone base, the telephone base shows
Registration slots are full and sounds two beeps.
1.
2.
3.
4.
5.
6.
•
•
Appendix
To register HS,
see manual.
Registering...
Please wait
HANDSET X
Registered
To Next Page
Loading...
Need help?
General
