Appendix
117
California Energy Commission battery charging testing instructions
This telephone is set up to comply with the energy-conserving standards right out of the box. These
instructions are intended for California Energy Commission (CEC) compliance testing only. When the
CEC battery charging testing mode is activated, all telephone functions on the cordless handsets,
except battery charging, will be disabled.
To activate the CEC battery charging testing mode:
1. When the telephone base is in idle mode, press and hold /HANDSET LOCATOR.
2. After about 10 seconds, when the IN USE light starts flashing and the screen displays
Deregister all devices?, release /HANDSET LOCATOR, and then press it again or press
MENU/SELECT within two seconds.
The process takes up to one minute to complete. When the phone successfully enters the CEC
battery charging testing mode, all handsets display To register HS, see manual.
When the phone fails to enter this mode, repeat the steps mentioned above.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back in. The
telephone base is powered up as normal.
2. Register your handsets back to the telephone base. See page 96 for handset
registration instructions.
BC
To Next Page
Loading...
Need help?
General
