Appendix
102
Screen display messages
Screen messages
No line
There is no telephone line connection.
No answer. Try
again.
The device(s) you are trying to transfer a call to is out of range,
off hook, or has no power.
No caller info
The caller information is unavailable.
Number already
saved
The telephone number you have entered is already in the
directory.
Not available
at this time
Someone else is already using the directory or caller ID log.
No Incoming PTT
The incoming PTT function is turned off. The handset will not
receive PTT calls.
Out of range OR
No pwr at base
The telephone base has lost power, or the handset is out
of range.
** Paging **
The cordless handset is paged by the telephone base.
Paging all
handsets
The telephone base is paging all cordless handsets.
Phone
The handset or telephone base is on a call.
Place in charger
The battery is very low. The handset should be charged.
Quiet mode on
QUIET mode is on.
Quiet mode is off
QUIET mode is turned off.
Rec mem full
The system recording memory is full.
Rec mem low
The system recording time is running short.
Recording message
The telephone is recording a message.
Registering...
Please wait
Handset registration is in progress.
Registration
slots are full
The telephone base has the maximum of 12 handsets
registered to it.
Registration failed
The handset registration is not successful.
Ringer off
The ringer is turned off.
Ringer muted
The ringer is off temporarily while the device is ringing.
Saved
An entry has been successfully saved in the directory.
Setup Ans sys...
The telephone base is playing voice guide.
Speaker
The handset or telephone base speakerphone is in use.
TRANSFER TO:
You have started transferring a call, and need to enter the
desired device number or choose all devices.
To register HS,
see manual.
Screen display before handset registration.
To Next Page
Loading...
Need help?
General
