AT&T DL72119 - Message Playback and Management

108
Answering system
Answering system settings
Remote access code
To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access
code is 19.
To change the remote access code:
1. Press MENU/SELECT in idle mode.
2. Press CID or DIR to highlight Answering sys, then press
MENU/SELECT .
3. Press CID or DIR to highlight Ans sys setup, then press
MENU/SELECT .
4. Press CID or DIR to highlight Remote code, then press
MENU/SELECT .
5. Use the dialing keys to enter a two-digit number.
-OR-
Press CID or DIR to scroll to a desired two-digit number.
6. Press MENU/SELECT toconrm.
Remote code
ECO
Remote code
19
ECO