AT&T DL72119 - Bluetooth Setup

13
Getting started
Installation options
Your telephone base is ready for tabletop use. If you want to mount your
telephone on a wall, use the provided wall-mount bracket to attach to a standard
dual-stud telephone wall-mounting plate. If you do not have this wall-mounting
plate, you can purchase one from many hardware or consumer electronics
retailers. You may need a professional to install the wall-mounting plate.
Tabletop to wall-mount installation
1. Plugthetelephonelineintothetelephonebase.IfyouareusingaDSLlter,
plugtheotherendofthetelephonelineintothelter.Routethetelephone
line cord (or DSLlter)throughthewall-mountbrackethole.
2. Align the holes on the wall-mount bracket with the standard wall plate and
slide the wall-mount bracket down until it locks securely.
3. Position the telephone base, as shown below. Insert the extended tabs
(marked B) of the wall-mount bracket into the slots on the back of the
telephone base. Push the telephone base down until it is securely in place.
4. Plug the power adapter into a power outlet not controlled by a wall switch.
Plug the other end of the power adapter into the telephone base. Bundle the
telephone line cord and power adapter cord neatly with twist ties.
3
2
4
1
B
A