Inspect also allows you to review your console’s features,
showing you what is programmed on your console’s fixed
feature buttons or the ranges for your DSS page numbers.
You can also use Inspect to view the busy status of the trunk
pools in your system or to see information about extensions
assigned to DSS buttons.
To Use Inspect
1. Press Inspct.
2. Select button you want to inspect:
• Press the call button for the held call (fast flashing green
light).
• Press the call button for conference call.
• Press the call or fixed feature button you want to check.
• Press the
Pool Status
button (to view trunk pools).
• Press a Page button (Page 1, Page 2, Page 3) on the DSS (to
view the first number in the range of numbers for that DSS
page button).
• Press the DSS button for an extension (to view extension
information).
• Press the
Alarm
button (to see the status of system alarms).
• Press any other button you want to inspect. See Note.
3. Press Home to leave the Inspect mode.
Note: You cannot inspect display buttons or dedicated
feature buttons. If you press a dedicated feature button
(Transfer, Conf,orHold) or a labeled display button (Menu
or Home), your console will leave Inspect mode and turn on
the feature for the button you pressed.
4-25
To Next Page
Loading...
Need help?
General
