Night Service
Night Service is used to send after-hours outside calls to
another phone or phones. You can send incoming calls to a
specific phone, such as the security office, or these calls can
ring a night bell or other alert. Also, to prevent unauthorized
after-hours use of phones, Night Service can be set up so that
you have to enter a password to make an outside call.
Night Service can be programmed to automatically turn on
and off at preset times. If your system is not programmed this
way, you must turn Night Service on when you leave for the
night and off when you start your day.
• Must be system-programmed.
• May require passwords.
• May be set up for automatic on/off.
To Turn Night Service On or Off
1. Press
Night Service
button.
The green light goes on when Night Service is on, and off when Night
Service is off. If a password is required, the green light will flash.
2. Enter password if required.
You must enter the password within 60 seconds or start procedure
again.
Note: If you make a mistake when entering the password,
you must start again.
4-33
To Next Page
Loading...
Need help?
General
