PROGRAMMING
HOW TO USE
To program a Saved Number Redial button for your voice terminal:
1
Label the button Saved Number.
2
Slide the T/P switch to P.
The voice terminal rings every 5 seconds to remind you that you are programming and that you
cannot place or receive calls.
3
Touch the button you want to program.
4
Dial *74 (you do not need to dial an outside number).
5 Slide the T/P switch to the center position.
You can use a programmed button or a dial code to access this feature.
To save a number for redialing:
1
Before you hang up your handset from a call in progress, touch Saved
Number or dial #23.
2
Hang up your handset.
The MERLIN Plus system saves this number until you repeat this procedure to
save another number.
To redial this number later:
1
Without lifting your handset, touch Saved Number or dial #23.
You voice terminal speaker goes on, and you hear dialing.
2
When you hear the other person answer, lift your handset and begin
talking.
If the line is busy, or if no one answers:
1
Touch Speaker to cancel the call.
5-62
Section 5: Reference
To Next Page
Loading...
