To use Monitor-on-Hold:
1
When you have been put on hold, touch Speaker.
2
Hangup.
3
When you hear the other person return to the call, lift your handset and
continue the call.
To use Group Listening:
1 Without hanging up, touch Speaker, and continue your conversation.
Special Characters in Dialing Sequences
DESCRIPTION
CONSIDERATIONS
ADMINISTRATION
PROGRAMMING
HOW TO USE
Pause
Y
OU may need to program a pause, stop, or switchhook flash into an Outside
Auto Did, a Personal Speed Dial, or a System Speed Dial sequence, or you
may need to switch from rotary to Touch-Tone signals in the middle of a
programmed dialing sequence. To do so, you must enter one or more special
Characters when you program the sequence.
The switchhook flash can be used only at the beginning of a programmed
dialing sequence.
None
None
Use the following procedures to enter special characters into a dialing
sequence.
Program a pause (1.5 seconds) into a dialing sequence. For example, you may
need a pause between a pool access code, such as a 9, and an outside
telephone number in an Outside Auto Dial sequence.
1
Dial the access code, such as a 9.
2
Touch Hold (Pause).
3
Dial the outside telephone number.
5-66 Section 5: Reference
To Next Page
Loading...
