CONSIDERATIONS
None
ADMINISTRATION
If your responsibilities do not include system administration, skip this
information.
To set your system for rotary dialing:
PROGRAMMING
HOW TO USE
1
2
3
4
Enter administration mode by sliding the T/P switch to P and touching
Administer.
Dial *39.
Touch Administer.
The console beeps twice.
Leave administration mode by sliding the T/P switch to the center
position.
If you need to reset the system for Touch-Tone dialing:
1
Enter administration mode by sliding the T/P switch to P and touching
Administer.
2 Dial *38.
3
Touch Administer.
The console beeps twice.
4
Leave administration mode by sliding the T/P switch to the center
position.
None
If you have telephone lines that carry rotary signals, you can switch to Touch-
Tone signals midway through a dialing sequence by using the Touch-Tone
Enable feature. (See "Touch-Tone Enable.")
MERLIN Plus System Features
5-79
To Next Page
Loading...
