PROGRAMMING
3
Touch Auto Intercom buttons until they show the paging group
assignment you prefer.
Green light on =
voice terminal is assigned to the group
Green light off =
voice terminal is not assigned to the group
4
Touch Administer.
The console beeps twice.
5
Follow the last three steps for each paging group you want to administer.
6
Leave administration mode by sliding the T/P switch to the center
position.
If you want to clear all entries from group 1 or from group 2:
1
Enter administration mode by sliding the T/P switch to P and touching
Administer.
2
Dial *71 for group 1 or *72 for group 2.
3
Touch Drop.
4
Leave administration mode by sliding the T/P switch to the center
position.
To program a Group Page button for your voice terminal:
70 = Page=All (all voice terminals in the system)
71 = group 1
72 = group 2
5
1
Label the button Group Page plus a group number.
2
Slide the T/P switch to P.
The voice terminal rings every 5 seconds to remind you that yo0u are programming and that you
cannot place or receive calls.
3
Touch the button you want to program.
4
Dial *91 plus a Group Page code:
Slide the T/P switch to the center position.
5-34
Section 5: Reference
To Next Page
Loading...
Need help?
General
