How to fix noisy talk-back on AT&T system?
If the talk-back feature on your AT&T system is noisy, check to see if shielded cable was used for the wiring. Ensure the cable shield is only connected at the controller end. If unshielded cable is in use, consider changing to shielded cable. Also, try removing the shield at the speaker end.
How to eliminate noise without music source on AT&T Controller?
If you're experiencing noise on the output in music mode without a music source connected to the input on your AT&T Controller, turn the Music Input volume control fully counter-clockwise (down). Also, check the programming options to see if music is disabled for the zone(s).
Why is remote amplifier not receiving audio from AT&T PagePac Plus Controller?
If a remote amplifier isn't receiving audio from the AT&T Controller, check the audio connections on pins 3 and 4 of J3. Also, ensure the zone option switch is in the Contact Closure Output position.
General| Manufacturer | AT&T |
|---|---|
| Model | PagePac Plus |
| Frequency Range | VHF/UHF (Specific frequencies depend on model and configuration) |
| Channels | Multiple (Configurable) |
| Power Supply | AC Power |
| Dimensions | Varies depending on configuration |
| Weight | Varies depending on configuration |
| Protocols Supported | POCSAG |
Provides a summary of PagePac Plus controller features, system components, and auxiliary equipment.
Step-by-step guide for determining features, verifying diagrams, pulling cables, and mounting.
Provides an overview of PagePac Plus system features and additional application capabilities.
Details controller specifications including capacities, dimensions, electrical, temperature, and environmental factors.
Explains power source for the PagePac Plus controller and zone expansion units.
Details mounting options for the PagePac Plus components in cabinets, racks, or walls.
Describes front and rear panel LED indicators and available connectors on the controller.
Lists compatible peripheral products and speakers for the PagePac Plus Controller.
Provides essential safety precautions for using and installing the PagePac Plus system.
Illustrates three system configurations: 70 Volt, Controller, and Hybrid.
Details zone connector capabilities and mode function slide switch settings for zone operation.
Explains DIP switch settings for zone expansion units to determine hardware configuration.
Provides steps for testing each zone after wiring and connection.
Offers guidance on troubleshooting and contacting customer support for system issues.
Lists common issues encountered when the paging system is not operating correctly.
Provides a table of problems, causes, and corrective actions for system issues.
Details component registration for the controller with the FCC and usage guidelines.
Addresses radio frequency interference and compliance with FCC Part 15 regulations.
Outlines the limited warranty and limitation of liability for the AT&T product.
To Next Page
