TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus February, 1988
AT&T PRIVATE PAY PHONE (ELECTRICAL & TELEPHONE WIRING
DIAGRAM)
IN THE KS-23224 SENTRY II POST
• POWER CABLE (D-STATION WIRE) -
(FROM POWER TRANSFORMER)
FROM LAMP IN KS-23222
OR KS-23223 ENCLOSURES -
/-• MODULAR 2 CONDUCTOR
TELEPHONE LINE CORD
(FROM CONNECTING BLOCK)
• COMPONENTS FURNISHED
WITH AT&T PRIVATE PAY PHONE
• POWER TRANSFORMER
(24 V AC)
LIGHT CONTROL (FURNISHED WITH
KS-23224, LIST lL, lLC, 2L, OR 2LC POSTS)
STATION PROTECTOR
CIRCUIT
BREAKER ENCLOSURE _____ _/
(FURNISHED BY TELEPHONE COMPANY
IF REQUIRED) PROTECTOR COVER
(FURNISHED WITH KS-23224, LIST lLC OR 2LC POSTS)
ELECTRICAL GROUND LUG
CONNECTINGBLOCK-----./
(FURNISHED WITH ALL KS-23224 POSTS)
UNDERGROUND ELECTRICAL ENTRANCE (110 V AC)
(CONNECT GROUND WIRE TO GROUND LUG· 12 AWG OR LARGER)
NOT SHOWN
TELEPHONE GROUND LUG
UNDERGROUND GROUND CABLE &
TELEPHONE ENTRANCE
Figure 16 Sentry II PostfBase
Installing the Sentry II Post/Base
To get the best noise protection, orient the post in a direction so that the front opening of
the enclosure will not face an excessive noise source (streets, railroads, etc.).
To mount the post:
1. Remove Panel From Post .
• Refer to Figure 1 5.
• Remove the 2 security screws at the top of panel (Item 2).
• Brace your knee against the right side of the post as viewed from the front (Item 2).
• Place both of your hands on the opposite side of the panel (Item 2).
• Pull the top and bottom of the panel simultaneously towards the right side of the
post (Item 2).
Owner Manual Page 41
To Next Page
Loading...
