TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus
February, 1988
Installing and Removing Instruction Cards
Do the following to install the customer instruction cards:
NOTE These instructions apply for both the top and bottom card
1. Loosen the card locking setscrew in the faceplate (refer to Figure 22) by turning it
counterclockwise with a No. 4 (.050) Allen wrench.
2. Push the top edge of the card up under the faceplate, and slide the card down into
place.
3. Place the card cover over card. (The top edge of card cover should also be under the
faceplate.) Slide the card cover down into place.
4. Ensure that the card is seated properly in slot.
5. Tighten the card locking setscrew in faceplate by turning clockwise.
Owner Manual
~
ILIILI IC
11:lll:llLI
11:lll:lll:l
11:ll!:IILI
0
LOCKING SETSCREWS
Figure 22 Card Locking Setscrews
Page 52
To Next Page
Loading...
