TCI Library www.telephonecollectors.info
AT&T Private Pay Phone Plus
February, 1988
Do the following to remove the customer instruction cards:
NOTE These instructions apply for both the top and bottom card
1. Loosen setscrew in faceplate by turning it counterclockwise.
2. Push up on card cover and instruction card with your fingers.
3. Pry bottom of card cover and instruction card out with small screwdriver or equivalent.
Installing and Removing Number Card
Do the following to install or remove the number card:
1. Write the telephone number of the AT&T Private Pay Phone
Plus on the card. Insert the
card into its slot on the phone, and then insert the number card cover into the slot. To
remove the telephone number card, either use a paper clip or your finger to pry the
cover and card from the slot.
Owner Manual
Page 53
To Next Page
Loading...
