AT&T Syn248 SB35031 - Making an Intercom Call

Outgoing Calls 24
Syn248 SB35031 Deskset User’s Guide Back to Contents
Making an Intercom Call
To make an internal (extension-to-extension) call, you must press the INTERCOM key as
shown in Figure 7 on page 15. By default, the fifth key down is the Intercom key, but
your system administrator can configure additional Intercom keys to give you more
Intercom lines.
By default, your Deskset uses an outside line any time you go off hook by lifting the
handset, pressing (SPEAKER), or by some other method. However, your system
administrator can configure your Deskset to use the Intercom line any time you go off
hook.
To make an intercom call:
1. With the Deskset in Idle mode, go off hook by lifting the handset, pressing , or by
some other method.
2. If necessary, press the INTERCOM key, then dial the extension number.
Instead of dialing after pressing the INTERCOM key, you can press ,
highlight the desired extension number, then press or SELECT to dial the
number.
3. When your Intercom call is answered, the active call screen appears.
12:30PM Thu Feb 25 2010
ExtList Page
Quick
Dial
Line 2
Line 3
Line 4
Line 1
ExtList
Call
12:30PM Thu Feb 25 2010
Graham Bell 219 0:20
Transfer Conf
Quick
Dial
Line 2
Line 3
Line 4
Line 1
More 1/2