Multiple Handset use
35
Call Transfer using intercom
At the telephone base:
1. During a call, press HOLD and the outside call is put on hold. Press the
MENU soft key and then press qCID or pDIR to scroll to Intercom, then
press the SELECT soft key.
-OR-
During a call, press the OPTION soft key and then press qCID or pDIR to
scroll to Intercom, then press the SELECT soft key. The outside call is put
on hold automatically.
2. When you have only one system handset, your telephone base shows
Calling handset and the handset rings and shows Base is calling.
-OR-
When you have more than one system handset, your telephone base
shows INTERCOM TO:, press qCID or pDIR to select a destination
handset and then press the SELECT soft key. The telephone base shows
Calling handset X. The destination handset rings and its screen shows
Base is calling.
3. To answer the intercom call on the destination handset, press
LINE 1/FLASH, LINE 2/FLASH, /SPEAKER or INT. The outside call is
still on hold. Both telephone base and the destination handset now
show Intercom. You can now have a private conversation between the
telephone base and the destination handset.
NOTES:
If you want to cancel an intercom call and reconnect to the outside call before the
destination handset answers, press the corresponding line button, /LINE 1 or
/LINE 2, on your telephone base.
If the destination handset does not answer the intercom call within 100 seconds, or if the
handset is in the directory or call log, or out of range, your telephone base shows Unable
to call try again and the outside call is still on hold. Press the corresponding line button,
/LINE 1 or /LINE 2, on your telephone base to reconnect to the outside call.
4. Press CANCEL or the END soft key on the telephone base. Both screens
show Intercom ended.
5. The telephone base and the destination handset show L1)ON HOLD if the
call is on line 1. Press LINE 1/FLASH on the destination handset to connect
the call on line 1. The same procedures apply if the call is on line 2.
•
•