AT&T TL88102BK User Manual

66
Answering system
Answering system settings
Remote access code
A two-digit security code is required to access the answering system
remotely from any touch-tone telephone. The preset code is 19. You can set
the code to any number from 00 to 99.
Using the telephone base:
1. Press the MENU soft key when the telephone base is not in use.
2. Press the SELECT soft key to select to select Answering sys.
3. Press qCID or pDIR to choose Mailbox 1 or Mailbox 2, then press the
SELECT soft key. The corresponding icon,
1
or
2, flashes on the screen.
4. Press qCID or pDIR to scroll to Ans sys setup, then
press the SELECT soft key.
5. Press qCID or pDIR to scroll toto scroll to Remote code, then
press the SELECT soft key.
6. Use the dialing keys (0-9) to enter a two-digit code.
Press CANCEL to delete a digit.
7. Then, p ress the SET soft key to confirm your setting.
There is a confirmation tone.
Using the handset:
1. Press the MENU soft key when the handset is not in use.
2. Press the SELECT soft key to select ANSWERING SYS.
3. Press qCID or pDIR to choose Mailbox 1 or Mailbox 2, then press the
SELECT soft key. The corresponding icon,
1
or
2
, flashes on the screen.
4. Press qCID or pDIR to scroll to Ans sys setup, then press
the SELECT soft key.
5. Press qCID or pDIR to scroll to Remote code, then press
the SELECT soft key.
6. Use the dialing keys to enter a two-digit code. Press
OFF/CANCEL to delete a digit.
7. Then, press the SET soft key to confirm your setting.
There is a confirmation tone. You can also press the
BACK soft key to exit to the previous menu without
making any changes.
NOTE: If you change the remote access code setting on either Mailbox 1 or Mailbox 2, it
applies to both mailboxes in your answering system.
1
# of rings
Remote code
Msg alert tone
SELECT
1
REMOTE CODE
__
SET
1
1
BACK
SELECT
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
BACK
SET
REMOTE CODE
__

AT&T TL88102BK Specifications

General

Brand	AT&T
Model	TL88102BK
Category	Cordless Telephone
Language	English