AT&T TL88102BK - Call Transfer and Conference Calls

Multiple Handset use
34
Call Transfer using intercom
Using the intercom feature to transfer an outside call to another system
handset or the telephone base. You can also share an outside call with
another system handset or the telephone base.
Transfer a call
From the handset:
1. During a call, press INT.
2. When you have only one system handset, your handset shows Calling base
and the telephone base rings and shows Handset is calling. The outside
call is put on hold automatically.
-OR-
When you have more than one system handset, the originating handset
shows INTERCOM TO:, press qCID or pDIR to select a destination and then
press the SELECT soft key. The outside call is put on hold automatically.
If you are calling the telephone base, your handset shows Calling base
and the telephone base rings and shows Handset X is calling.
If you are calling another handset, your handset shows Calling handset X
and the destination handset rings and shows Other handset is calling or
Handset X is calling.
3. To answer the intercom call, press /LINE 1 or /LINE 2 on the
telephone base, or press LINE 1/FLASH, LINE 2/FLASH, /SPEAKER or
INT on the handset. The outside call is still on hold. Both the originating
handset and the destination handset or the telephone base now show
Intercom. You can now have a private conversation between the handset
and the telephone base or between the two handsets.
NOTES:
If you want to cancel an intercom call and reconnect to the outside call before the
destination handset or telephone base answers, press the corresponding line button,
LINE 1/FLASH or LINE 2/FLASH, on your originating handset.
If the destination handset or telephone base does not answer the intercom call within 100
seconds, or if the handset is in the directory or call log, or out of range, your originating
handset shows Unable to call try again and the outside call is still on hold. Press the
corresponding line button, LINE 1/FLASH or LINE 2/FLASH, on your originating handset
to reconnect to the outside call.
4. Press OFF/CANCEL or the END soft key on the originating handset. Both
screens show Intercom ended.
5. The originating handset and the destination handset or telephone base
show L1)ON HOLD if the call is on line 1. Press LINE 1/FLASH on the
destination handset or press /LINE 1 on the telephone base. The same
procedures apply if the call is on line 2.
•
•
•
•