1
Learning Device Codes (continued)
STEP 6. Press the next key you want to program on your RF Remote
Control once (VOLUME or VOLUME or MUTE ).
STEP 7. Press and hold the corresponding key you want programmed
from the original remote until the RF Remote Control emits a
long beep, indicating it has “learned and saved” the key
command.
STEP 8. To program additional keys, repeat steps 6 and 7.
STEP 9. To save the learning, press the LEARN key. This will also
exit Learning.
NOTE: If the programming is interrupted or inactive for more than 15 seconds,
the remote will emit 8 short beeps and the mode keys will flash. This indicates
the remote has left the programming mode and returned to normal operation
without saving any changes.
Quick Setup Guide
2
4
1
3
5
1”-2”
To Next Page
Loading...
