Advanced Features Setup
A. Volume or Channel Control Options
By factory default the Volume and Channel commands are sent to the AT&T U-verse Receiver. Once
the TV has been programmed, the POWER key will control both the U-verse Receiver and the TV; the
Volume controls (VOL+ or -, MUTE) will go to the TV, and the Channel controls (CH+ or -, LAST) will
be sent to the U-verse Receiver. Once you have programmed a device to a mode key, you can send
the volume commands to that device rather than the TV or U-verse Receiver (e.g. a home theatre
receiver). Follow the instructions in Section A1 to have the Volume commands always go to one
device. If you want the Volume (or Channel) commands to go to a programmed device when it has
been selected using the mode key, follow the instructions in Section A2.
A1. Always Send Volume or Channel Commands to One Device
STEP 1. Press and hold both the AT&T and OK keys for one second, then release.
All the mode keys flash twice.
STEP 2. Enter 9 5 5 for volume, or 9 6 6 for channel using the numeric keypad. The
AT&T key will flash twice to confirm the correct entry.
STEP 3. Press the mode key ( or or ) for the device you want to always
control the volume or channel (e.g. AUX for your Home Theater).
STEP 4. The selected mode key (e.g. AUX ) will give a long flash with a
long beep to confirm successful programming.
To Next Page
Loading...
