Quick Setup Guide
3B: Learning Device Codes
To use this method, you must have the original remote for the device you wish to program.
STEP 1. Press and hold the LEARN key until the four
mode keys flash in sequence, then release.
STEP 2. Press the mode key for the device you want
to control. The other mode keys will stop flashing.
The red LED SELECT KEY TO LEARN indicator
on your U-verse remote will flash.
STEP 3. Place the RF Remote Control head-to-head
with your original remote (about 1” – 2” apart).
STEP 4. Press the key you want to program on your RF Remote Control once. (The first key
programmed should be the POWER key.) After pressing the key to program,
the green READY TO LEARN LED indicator will light.
STEP 5. Press and hold the corresponding key you want programmed from the original
remote until the RF Remote Control emits a long beep, indicating it has
“learned” the desired command. (For the first key, this should be the
POWER key.)
2
4
4
1
1
3
2
3
5
5
To Next Page
Loading...
