Search for Device Codes (continued)
NOTE: If the device does not turn off and you have searched all available codes, you will
hear 8 beeps and the mode key will flash 8 times. If this happens, please start over at
Step 2 or proceed to 3B, Learning Device Codes.
NOTE: If the device does not turn on, you may have pressed the SCAN \FF key too many
times. Press the REW\ SCAN key to scan backwards and test the POWER button again.
STEP 6. Check VOLUME and and MUTE . Do not test using REW\ SCAN
SCAN \FF EXIT CHANNEL and FWD or number keys. If
there is any problem with any of the keys, press the SCAN \FF button and
search until you find a code which will operate all the functions properly.
STEP 7. Press the ENTER key to save the programming. The appropriate mode key
will give a long flash with a long beep, indicating successful programming.
NOTE: If the programming is interrupted or inactive for more than 15 seconds, the remote will
emit 8 short beeps and the mode keys will flash. This indicates the remote has left the
programming mode and returned to normal operation without saving any changes.
Quick Setup Guide
To Next Page
Loading...
