Quick Setup Guide
MODE KEYS
SCAN FORWARD
3A. Search for Device Codes
The Search method will scan through all the IR codes to find one that works with your TV
or other device.
STEP 1. Power on the device to be programmed.
STEP 2. Point the RF Remote Control at the selected device.
STEP 3. Press and hold a mode key or or along
with the ENTER key. Hold both keys for
one second, then release. The four mode keys on
the RF Remote Control flash twice to indicate you
are in search mode.
STEP 4. Search by pressing the SCAN \FF key
repeatedly until the device turns OFF. (The selected mode key will flash once
for each press of the SCAN \FF key.) Pause briefly between each key
press to allow your device enough time to respond.
STEP 5. Press the POWER button on the RF Remote to power the device back on.
To Next Page
Loading...
