AT&T U-Verse - Quick Setup Guide; How to Activate Batteries; How to Install USB Converter

1. How to activate the batteries (two AA Alkaline batteries
have been pre-installed for your convenience)
STEP 1. Pull the Tab on the back of the RF Remote Control
straight out with one smooth motion.
STEP 2. Press the AT&T key. The AT&T key will light up.
If the AT&T does not light up, please refer to
Troubleshooting on Page 19 of this manual.
2. How to install the USB Converter
STEP 1. Remove the USB plug cover from the
USB Converter.
STEP 2. Plug the USB Converter into the USB
port on the front of your AT&T U-verse
Receiver. Your port location may differ
from the picture shown. The blue
power LED on the USB Converter will
light and stay on.
Quick Setup Guide
Pull Tab on
Battery
Compartment
USB Plug
USB Plug
Cover
Pairing
Button
Power LED