Advanced Features Setup
Turning the Keypad Backlighting ON (continued)
STEP 2. Enter 9 9 1 using the numeric keypad. The AT&T key will give a long flash and a
long beep, indicating successful programming. The RF Remote Control then returns
to its normal state.
D. Home ID
Your RF Remote Control and USB Converter were paired at the Factory. In the event you are
receiving interference from another RF device, your RF Remote Control and USB Converter
allow you to create a new ‘Home ID’ using any number from 0000 to 9999. To change your
Home ID:
STEP 1. Press and hold the Pairing Button on the USB
Converter until the blue Power LED turns off.
The USB converter is now ready to be programmed.
2
1
To Next Page
Loading...
