Home ID (continued)
NOTE: The USB converter will remain in programming mode for two minutes to receive the
Home ID command from the RF Remote Control. If the blue LED light turns on, it means the
USB converter timed out and you must start over.
STEP 2. On the RF Remote Control, press and hold both the AT&T and OK keys for
one second, then release. All the mode keys flash twice.
STEP 3. Enter 9 1 4 using the numeric keypad. The AT&T key will flash twice indicating
correct entry.
STEP 4. Using the numeric keys on the RF Remote Control, enter the Home ID you want to
program (any 4 digits using “0-9” such as 1234).
STEP 5. The AT&T key on the RF Remote Control will give a long flash and sound a long
beep. At the same time, the blue Power LED on the USB converter will flash for 2
seconds then remain on. This indicates Home ID pairing was successful.
Advanced Features Setup
To Next Page
Loading...
