A2. Send Volume or Channel Commands only to the Device Mode Selected (e.g. in
DVD mode, the DVD player controls the audio, but in TV mode the TV controls the audio)
STEP 1. Press and hold both the AT&T and OK keys for one second, then release.
All the mode keys flash twice.
STEP 2. Enter 9 5 5 for Volume or 9 6 6 for Channel using the numeric keypad. The AT&T
key will flash twice to confirm the correct entry
STEP 3. Press the ENTER key. The AT&T key will give a long flash with a long beep
to confirm successful programming.
NOTE: If the programming is interrupted or inactive for more than 15 seconds, the remote will emit 8
short beeps and the mode keys will flash. This indicates the remote has left the programming mode
and returned to normal operation without saving any changes.
NOTE: The mode key must first have been programmed for your device.
Advanced Features Setup
To Next Page
Loading...
