Advanced Features Setup
B2. To Power Devices On and Off Independently
STEP 1. Press and hold both the AT&T and OK keys for one second, then release.
All the mode keys flash twice.
STEP 2. Enter 9 7 7 using the numeric keypad. The AT&T key flashes twice.
STEP 3. Press the ENTER key to complete the programming. The AT&T key
will give a long flash with a long beep indicating successful programming.
NOTE: If the programming is interrupted or inactive for more than 15 seconds, the remote
will emit 8 short beeps and the mode keys will flash. This indicates the remote has left the
programming mode and returned to normal operation without saving any changes.
To Next Page
Loading...
