6.6 Floor Finishes
15mm blue metal (minimum 100mm thick) over plastic sheeting,
except where the gas meter set is located in a position where t
of the building. In this case, the gas meter riser shall be installed in a manner that will provide
future access to the gas service riser pipework both above and below ground.
6.7 Security Access
All gas meter enclosures must have approved Western Australian Services (WAS) locks
installed for maintenance and emergency access. For more information refer to Section 5.7.2
Mandatory Lock Requirements.
6.8 Signage
Recesses enclosed with doors must have appropriate signage on the outside to indicate gas
meters are located inside.
6. Gas Meter Banks
and Enclosures
37