QSG_F600.415.00_EN_01 / 2019-04-16
33 / 38
Additional functions
Label Function Description
24V OUTPUTS
Auxiliaries output 24 V Available outputs for external automatism
ABSOLUTE
Absolute Display the absolute value of the results
ATF
ATF time Absorb the important leak variations at the
defined time
ATR0/ATR1/
ATR2/ATR3
ATR 0 - 3 Specific filters on leak measurement
AUTO CONNECT
Automatic connector Function to manage automatic jigs
BUZZER
Buzzer Buzzer activation configuration
BYPASS
Bypass function Additional valve for faster filling
CODE READER
Bar code reader Bar code configuration
CUT OFF
Cut off All the measurements that are lower than the
configured rate have the value 0
DISP. OPT.
Display option Display of an additional information on a second
line
DISPLAY MODE
Display Mode Leak measurement resolution
END OF CYCLE
End of cycle Several automatism case depending on fail part
management
FILL MODE
Fill types Special filling methods
FILTER
Filtering Stabilize the measurement values
FLOW LEVEL
Flow level Add a minimum fail parameter
NAME
Name Program customization
NO NEGATIVE
No Negative Replace negative value per 0
PEAK HOLD
Peak hold Give as result, the highest flow during the test
time
PR:SEQUENCE
Sequencing Allowed program automatic sequencing
PRE-FILL
Pre-fill types Special filling methods
PRESS.CORR.
Pressure correction Calculates leak at a defined pressure value
PRESSURE DROP
Pressure drop Pressure drop mode function in the Desensitized
mode
REWORK LIMIT
Rework limits Additional levels for specific reworkable parts
SIGN
Sign Return opposite result
STAMPING
Stamp Pneumatic or electric output to identify the part
SYNC. TEST
Synchro test A programmable input allows to pass from
Stabilization to Test phase
TEST TIME*100
Longer test time Allowed longer test time (1s = 100s)
UNITS
Units Access to International System or American or
Custom Units
VALVE CODES
Valve codes Available outputs for external automatism
Some functions are available depending on software version.
To Next Page
Loading...
