Atexco S - Troubleshooting Malfunctions; Machine Malfunction Codes and Treatment

Model S High Speed Sublimation printer
55
Chapter 7 Eliminate of frequent malfunction
7.1 Machine malfunction code and treatment
5
104
EC_CARRIER_STALL
Print head carrier resistance
is large
Unnormal grating signal, motor or motor
signal
6
105
EC_CARRIER_REVERSE_DIR
Print head carrier reverse
Grating B phase opposite, motor direction
opposite
7
106
EC_PRINT_WIDTH_OVER
Width exceeding
Check the width of the design and print
start point
8
107
EC_CAR_ZERO_SENSOR_NOT
Print head carrier Zero
Sensor Error
Print head carrier Zero Sensor signal
unnormal
9
108
EC_ENCODER_CHECK_ERROR
Grating Detection Error
Grating Signal unnormal
10
109
EC_SDRAM_DATA_ERR
SDR Detection error
Return to manufacturer
11
110
EC_PCVERSION_ERROR
PC Driver error
Misuse of Printing Tools
12
111
EC_SURPLUS_SQUARE_LIMIT
squares not enough
Registered squares not enough
13
112
EC_CAPSENSOR_ERR
Induction error of lifting ink
station
Inductor unnormal in lifting ink station
14
113
EC_UART1_SENDCMM_ERR
Communication error of
mainboard and carrier board
Optical Fiber Wiring or Programming
Problems
15
114
EC_ZERO_BALANCE
The print square is zero
Registered Squares Exhausted