32
Keep This informaTion in a safe place
Configured Parameters Reference Data
Model Number ______________________________
Serial Number _______________________________
Zone Location _______________________________
Firmware Version No. _________________________
(Displayed when the controller is powered up after all the segments on both lines of the display have been tested.)
Please keep this information handy – in case your controller should lose its configured initial parameter values or for easy reference
when setting up a new controller.
After autotuning, and when your controller is controlling well, we recommend you write the displayed value for each of the menu
parameters listed below. If you do not use a listed parameter, indicate “N/A”. Using this information to document your parameter
settings could reduce your downtime.
Menu 2 Value Default Menu 3 Value Default Menu 4 Value Default Menu 5 Value Default
02 03 04 05
Gn.o1 20 ALr1 Id.no * 1 SnSr J
Gr.02 1. 0 ALr2 bAUd * 12.0.7
rAtE 0 CY.t1 5 CAL.L --- Sn.00
rSEt 0 CY.t2 5 CAL.H --- dEC.P
dPnG nL SP.tt OFF FiLt 0. 5
H.HYS L.SP.L 0 Ht.rd * OUt1 HT.P
C.HYS U.SP.L 1400 Ht.SP * OUt2 CL.P
C.SPr
L.SCL CoL.t NOR
HYS1 H.SCL
HYS2 A1.HL Hi
SPr.2 A1.Pd PR
A1.OP OFF
A2.HL LO
A2.Pd PR
A2.OP OFF
UnIt F
To Next Page
Loading...
