User manual
2920 1456 03 10
4.3 Calling up other menus
Starting from the Main screen:
- Use the ↓ key (1) for a quick look at the actual compressor status (see section 5).
- Press the key Menu (F1); the option Status data will be followed by a horizontal arrow:
- either press the tabulator key (2) to select this menu
- or use the ↓ key (1) to scroll until the desired submenu is followed by a horizontal arrow and
then press tabulator key (2) to select this menu.
5 Quick look at actual compressor status
Procedure
1. Starting from the Main screen (see section 4.2), press the ↓ key: A screen similar to the one
below appears:
Auto Operation
Local Control
Timer Active
Main Help Xtra
↓
F1 F2 F3
Fig. 5.1 Example of an actual compressor status display
Line 1 indicates the automatic or manual operation status of the regulator:
<<Auto operation>> means that the regulator automatically adapts the operation of the
compressor, i.e. matching the compressor output to the air consumption.
Line 2 indicates whether the regulator operates in local control or remote control mode:
<<Local control>> means that the start/stop buttons on the keyboard are activated.
<<Remote control>> means that these functions are controlled remotely. Consult Atlas Copco.
Line 3 indicates whether the timer which generates time-based start and stop commands is activated
or not. See section 14.
See section 2 for the functions of keys Main, Help and Xtra.
2. Press the ↓ key to get other data (actual compressor conditions of the compressor) as shown in
Fig. 4.1.
To Next Page
Loading...
