Atlas Copco Elektronikon II - Modifying Parameters

User manual
2920 1456 03 17
Setpoint 1
Bar 7.0
Menu Mod
↓
F1 F2 F3
Fig. 10.1 Modify setpoint screen
11 Modifying parameters
Function
To modify a number of parameters as mentioned in Fig. 4.1.
Procedure
1. Starting from the Main screen (see section 4.2):
- press the key Menu (F1)
- press the ↓ key until the option Modify Params is followed by a horizontal arrow
- press the tabulator key (2) to activate the menu
2. Use the ↓ key until the option Parameters is followed by a horizontal arrow
3. Press the tabulator key (2): the first item (Fan Mot St/Day) and its setting will appear.
Fan Mot St/Day
Number 240
Menu Mod
↓
F1 F2 F3
Fig. 11.1 Modify parameters menu
4. To modify this setting, press the key Mod (F2); the setting will blink.
5. The key Lim (F2) can be used to find out the limitations for the parameter. Use the ↓ or ↑ arrow
key to change the value.
6. Press the key Prog (F1) to program the new setting or the key Canc (F3) to cancel the
modification operation.
7. The procedure to modify other parameters is similar.