User manual
2920 1456 03 22
14 Programming Clock function
To program:
- time-based start/stop commands for the compressor
- time-based change-over commands for the net pressure band (see also section 10)
14.1 Programming start/stop/pressure band commands
In this example, the compressor will be programmed as follows:
- On Monday at 06:15 starting in pressure band 1
- On Friday at 18:00 changing over to pressure band 2
- On Saturday at 18:00 stopping
1. Starting from the Main screen (see section 4.2):
- press the key Menu (F1)
- press the ↓ key until the option Modify Params is followed by a horizontal arrow
- press the tabulator key (2) to activate the menu
2. Use the ↓ key to scroll until the option Clock function is followed by a horizontal arrow. Press the
tabulator key (2); following screen appears:
Clock Function
Not activated
→
Menu Mod Del
F1 F2 F3
3. Press the tabulator key (2); following screen appears:
Monday
→
Tuesday
Wednesday
↓
Menu Mod Del
F1 F2 F3
To Next Page
Loading...
