User manual
2920 1456 03 28
Deleting a specific start/stop/pressure band command
Scroll through the display until the desired start, stop, band 1 or band 2 command line is followed by a
horizontal arrow. Press the key Del (F3). A question to confirm the deleting operation will appear.
15 Configuration menu
Function
To reprogram a number of parameters. See Fig. 4.1.
Procedure
1. Starting from the Main screen (see section 4.2):
- press the key Menu (F1)
- press the ↓ key until the option Modify Params is followed by a horizontal arrow
- press the tabulator key (2) to activate the menu
2. Use the ↓ key to scroll until the option Configuration is followed by a horizontal arrow.
3. Press the tabulator key (2): The first option shown is <<Time>>. If another option is desired, scroll
through the display (using ↓ or ↑ keys) and select it using the tabulator key (2).
4. In case of option <<Time>>, the second line on the screen indicates the actual setting, e.g. 14:30.
5. If it is desired to modify the time, press key <<Mod>>. If not, press key <<Menu>> to return to the
submenu.
6. After pressing the key Mod, the first field (14) will blink. Modify the hours using the ↓ or ↑ keys.
Then press the tabulator key (2) to go to the next field (i.e. 30). The setting of this field can now
be modified with the ↓ or ↑ keys.
7. The bottom line of the display will show two options:
- Prog to program the new setting
- Canc to cancel the new setting
8. Proceed in a similar way for the other parameters to be modified.
To Next Page
Loading...
