Atlas Copco EP5PTI19 HR10-MT

EP5PTI19 HR10-MT EN Service
© Atlas Copco Industrial Technique AB - 9839 0661 01
27
Test after service
Perform a Tool condition test to make sure that the tool is working properly.
Tool condition test
A Static Torque transducer SRTT
B ST Analyzer (set at 850 Hz)
1. Test the free speed in the forward direction with the tachometer.
Make sure that the tool runs on full speed regardless of AutoTrim or Trim setting. If the tool is used
with AutoTrim, also test the AT function.
Also test the AutoTrim function.