Atlas Copco PTS 916 Cd - Start Failure Status; Shutdown Status

Instruction manual
Preliminary 35
4.4.11 Start failure status
First a stopping procedure is executed, and the operator has to wait.
Sreen A: Start failure, origin in Permissive start status.
Sreen B: Start failure, origin in Cranking status.
Other actions and signals have no effect in this status.
4.4.12 Shutdown status
First a stopping procedure is executed.
Other actions and signals have no effect in this status.
S Warnings R Are shown on the screen
A Emergency Stop button R To emergency Stop status (see
section 4.4.13)
A ↓-button, press once R Set pressure - 0.1 bar
A
↑ -button, press once R Set pressure + 0.1 bar
A ↓-button, press continuously R Set pressure - 0.1 bar/second
A
↑ -button, press continuously R Set pressure + 0.1 bar/second
A Power OFF switch R End of operation
A Reset button R To Ready for Start status (see
section 4.4.2)
S Warnings R Are shown on the screen
A Emergency Stop button R To emergency Stop status (see
section 4.4.13)
A ↓-button, press once R Set pressure - 0.1 bar
A
↑ -button, press once R Set pressure + 0.1 bar
A ↓-button, press continuously R Set pressure - 0.1 bar/second
A
↑ -button, press continuously R Set pressure + 0.1 bar/second
A Power OFF switch R End of operation
A Reset button R To Ready for Start status (see
section 4.4.2)