Atlas Copco PTS 916 Cd - Operation and Stopping Procedures

38 Preliminary
PTS 916 Cd
These parameters are:
– Compressor status
–Engine RPM
–Set RPM
– Air discharge pressure
– Set pressure
– LP intercooler pressure
– MP intercooler pressure
– Compressor oil pressure
– Engine oil pressure
– Engine fuel pressure
– Ambient temperature
– LP element temperature
– MP element temperature
– HP element temperature
– Compressor oil temperature
– Air discharge temperature
– Air discharge temp. Setting
– Air disch. Temp. Valve pos.
– Coolant temperature
– Fuel temperature
– Fuel level
– Engine fuel consumption
– Battery voltage
– Loading valve status
– Engine power contact
– Starter engine status
– Oiler valve status
– Blow-off valve status
– Flap lock solenoid
– Engine load
– Engine boost pressure
– Air inlet temperature
Other actions and signals have no effect in this status.
Other actions and signals have no effect in this status.
4.5 During operation
Regularly carry out following checks:
– Check alarm lamp at the front and alarm lamp and horn at the back
of the unit.
When starting up the unit and also when a shutdown occurs, the
alarm lamps and the horn will be activated. But when a warning
occurs, only the lamps will be activated.
– Check the air filter service indicator.
If the yellow signal shows in the window of the indicator (see
section 5.4.3), clean or replace the filter elements.
– Check the air outlet temperature of the MP compressor element.
4.6 Stopping instructions
– Close the air outlet valve(s).
– On the User Interface, push the function button below the indication
Noload.
– Push the Stop button.
– Once the engine has stopped, switch the control panel power switch
to the OFF position.
– Turn OFF the battery switch.
S Shutdowns R To Shutdown status (see section
4.4.12)
A Time-out R Back to active compressor status
A Emergency Stop button R To Emergency Stop status (see
section 4.4.13)
A ↓-button R Scroll text down
A
↑ -button R Scroll text up
A Return button R Back to active compressor status
A Stop command R Same function as in the active
compressor status
The pressure is not immediately relieved from the
unit, when the Stop button is pushed.
!