Atlas Copco PTS 916 Cd - Maintenance and Service; Maintenance Schedule and Oil;Filter Procedures

Instruction manual
Preliminary 39
5 Maintenance and service
Notes:
The initial service pak, which has been supplied with the unit, should be performed after the first 50 hours.
(1) More frequently when operating in a dusty environment.
Maintenance schedule Daily every
500
hours
every
1000
hours
every
2000
hours
every
3000
hours
every
4000
hours
every
8000
hours
every
10000
hours
Service pak - 2912 6046 05 2912 6047 06 2912 6048 07 ----
Engine oil level Check Check Check Check Check Check Check
Engine oil Add Change Change Change Change Change Change
Engine oil filters Replace Replace Replace Replace Replace Replace
Engine generator drive belt Check Check Check Check Check Check
Engine fan drive belt Check Check Check Check Check Check
Engine valve clearance Inspect /
Adjust
Engine fan drive Grease
Engine crankcase breather Clean
Electronic unit injector Inspect /
Adjust
Engine timing sensors Check / Clean / Calibrate
Fan drive Grease
Compressor oil level Check Check Check Check Check Check
Compressor oil Change
Compressor oil filter Replace
Service filter water separator Clean Clean Clean Clean Clean Clean
Air filter vacuum indicator
Vacuator valve (dust ejector) Empty Empty Empty Empty Empty Empty Empty
Air filter elements (1) Clean Replace Replace Replace Replace Replace
Air filter safety cartridge Replace Replace Replace Replace
Gear casing breather pot Clean
Silencers glasswool and insert Replace every 2 years
Primary fuel filters (water
separators)
Drain Replace Replace Replace Replace Replace Replace
Secondary fuel filters Replace Replace Replace Replace Replace
Water and sediment in fuel tanks Drain Drain Drain Drain Drain
Coolant levels (radiator) Check Check Check Check Check Check
Coolant condition Check Replace
Cooler system water temperature
regulator
Replace
Spark arrestors Inspect Inspect Inspect Inspect
Electrolyte and terminals on
batteries
Check Check Check Check Check
Safety / relief valves Test Test Test Test
Roller diaphragm of unloader
cylinder
Replace
Parts of unloader cylinder Replace
Diaphragm of the balancing
pistons
Replace
Check valve in compressed-air
system
Replace
Tension and condition of poly V-
belts
Check Check Check Check Check
Routing and condition of flexible
hoses
Check Check Check Check Check
Air, oil, water and fuel system
Turntable Grease GreaseGreaseGreaseGrease
Keep the bolts of the housing, the lifting eye, the towbar and the axle securely tightened.
Refer to “Technical specifications” on page 55 and to “Torque values” on page 55.
!